3 reloading factory default settings, 4 setting up the snmp, Reloading factory default settings – GeoDesy FSO Next series User Manual
Page 32: Snmp
GeoDesy Kft.
H-1116 Budapest, Kondorfa str. 6
7.3 Reloading factory default settings
Should you need to reload the original factory settings follow the steps
1. unplug the POE RJ45 cable
2. replug the POE RJ45 cable
3. unplug the POE RJ45 cable within 3 seconds
4. repeat procedure 3 times.
5. plug the POE RJ45 cable into the system, and leave it plugged in.
After this the system resets the following information to the
- IP address
- Username
- Password
- Device name
- SNMP settings
- Alerts
- Auto MDI/MDIX
- NPASD (if avialable)
7.4 Setting up the SNMP
Please check the GD view manual for details how to proceed to this point
On Figure 1 you can see our test setting. The
LaserHeadAlarm (OID:
of the alarms will go on (for alarm setting please see chapter 5.4)
LaserHeadAlarmCancel
(OID:
this trap will be sent
DeviceDown (OID:
1.3.6.1.4.1.17857.0.1103) This trap is being sent when the
SNMP agent is disabled
Telefon: 06
. 6-8.
E-mail: info@geodesy
http://www.
32
Reloading factory default settings
Should you need to reload the original factory settings follow the steps
unplug the POE RJ45 cable
replug the POE RJ45 cable
unplug the POE RJ45 cable within 3 seconds
repeat procedure 3 times.
plug the POE RJ45 cable into the system, and leave it plugged in.
After this the system resets the following information to the factory default.
NPASD (if avialable)
SNMP
view manual for details how to proceed to this point
1. Figure
On Figure 1 you can see our test setting. The GD-View is sending 3 traps
1.3.6.1.4.1.17857.0.1201) This trap will be sent after any
of the alarms will go on (for alarm setting please see chapter 5.4)
(OID: 1.3.6.1.4.1.17857.0.1202) After the alarm goes off
1.3.6.1.4.1.17857.0.1103) This trap is being sent when the
Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
http://www.geodesy-fso.com
Should you need to reload the original factory settings follow the steps below.
plug the POE RJ45 cable into the system, and leave it plugged in.
factory default.
view manual for details how to proceed to this point
View is sending 3 traps
1.3.6.1.4.1.17857.0.1201) This trap will be sent after any
1.4.1.17857.0.1202) After the alarm goes off
1.3.6.1.4.1.17857.0.1103) This trap is being sent when the