GeoDesy FSO Next series User Manual
Page 16
GeoDesy Kft.
H-1116 Budapest, Kondorfa str. 6
6.1.1 Alignment of the X series
The first step after the unit was placed to the
bracket, and turns the units facing each other.
On the back of the receiver you can
find the LEDs for the local received
level and the remote received level.
This help will be very useful because
as soon as you have
very easy to achieve
movement to the other side. For further information please check the
Meanings of the LEDs
How to use the alignment base
1. Loose the Coarse locker on the
horizontal as well as on the
vertical side with a 10mm
spanner
2.
Move the head left
down you should use the built in
telescope to lit up a few LEDs on
the remote end.
3.
When you have lined the unit up
to a rough position lock the
coarse locker with a 10mm
spanner.
4.
Repeat step 1-4 on the remote
end.
5. On the bottom of the unit you
can find fine tuning screws one for horizontal and one for vertical.
6. No tightening is needed on any other screw than the coarse locker.
Telefon: 06
. 6-8.
E-mail: info@geodesy
http://www.
16
X series
The first step after the unit was placed to the
bracket, and turns the units facing each other.
On the back of the receiver you can
find the LEDs for the local received
level and the remote received level.
This help will be very useful because
as soon as you have received – which is
very easy to achieve – you can see the effect of your local sides
vement to the other side. For further information please check the
Meanings of the LEDs chapter.
How to use the alignment base
Loose the Coarse locker on the
horizontal as well as on the
vertical side with a 10mm
Move the head left - right up
down you should use the built in
telescope to lit up a few LEDs on
When you have lined the unit up
to a rough position lock the
coarse locker with a 10mm
4 on the remote
On the bottom of the unit you
ine tuning screws one for horizontal and one for vertical.
No tightening is needed on any other screw than the coarse locker.
Telefon: 06-1-481-2050
Fax.: 06-1-481-2049
http://www.geodesy-fso.com
you can see the effect of your local sides
vement to the other side. For further information please check the
ine tuning screws one for horizontal and one for vertical.
No tightening is needed on any other screw than the coarse locker.