GeoDesy FSO GD series - Manual (Page 65)

com
http://www.geodesy-fso.com
65
GeoDesy Kft. Telefon: 06-1-481-2050
H-1116 Budapest, Kondorfa str. 6-8. Fax.: 06-1-481-2049
E-mail: info@geodesy-fso.
The necessary power can be supported to the
head by the connector which can be seen in the
figure next to this text. Order of the cables from
the head: (the four-twisted-pair-wired cable)
• Not
connected
• Red - +12V
• Twisted green-yellow - GND
• Black - -12V
1.
Remove the connector from the slot
2. Connect the cables /using the cable shoe/
3. Reconnect the connector to the slot
4. Secure the connector in the slot /make sure it is seated securely,
connectors clips are latched/
9.4.3 Fixing the heads
Your GD-5000 head can be fixed to its stand with
an Alignment Base Unit (ABU). On the figure you
can see an ABU, and a plinth of a
GD-5000 unit,
and the necessary fixing parts. The necessary
nuts and washers can be found on the legs of the
head. The steps of the fixing are:
• First, fix the ABU to the stand using the
washers and nuts
• Place the head to the ABU
• Fix the bolts with the nuts, using the
washers
• Tight up all the nuts.