GeoDesy FSO GD series - Manual (Page 39)

com
http://www.geodesy-fso.com
39
GeoDesy Kft. Telefon: 06-1-481-2050
H-1116 Budapest, Kondorfa str. 6-8. Fax.: 06-1-481-2049
E-mail: info@geodesy-fso.
9.2.4 Alignment of the heads
Steps of the head fixation
• Target Side B with the crosshair built in to the
head on Side A!
• Screw the two nuts up tight on both heads,
which are used for the fixing the vertical
direction, but be careful that the heads do not
move out from its position!
• Screw the three nuts up tight on both heads,
which are used for the horizontal fixation, but be
careful that the heads do not move out from its position!
• Repeat this on the other side of the link!
• Place up the spacers on both sides!
Place the two spacers where the figure shows to.
Open the spacers until it reaches the bottom of the upper
plate of the ABU! Repeat this on the back side too!
Then do the same on the remote side too!