Gamber-Johnson MCS-CUP2 User Manual
Page 2
If you need assistance or have questions, call Gamber Johnson at 1-800-456-6868.
Attaching MCS-CUP & MCS-CUP2 to DS-POLE assemblies (Fig. 2)
Note: When attaching the cupholder assemblies to a DS-POLE a U-bolt coupling is required,
contact Gamber-Johnson if one was not provided.
1. Remove the cupholder (item 1), from bracket (item 2), by removing two 8-32 x .25 phillips pan
head screws (item 3).
2. Slide U-bolt coupling (item 4), onto DS-POLE. Attach the bracket (item 2), to the U-bolt
coupling using two hex nuts (item 5), supplied with the U-bolt coupling. While tightening hex
nuts position bracket in desired location on the pole.
3. Replace cupholder on bracket and fasten with two 8-32 x ,25 phillips pan head screws. DO
NOT OVER TIGHTEN AS THE CUPHOLDER MAY BE DAMAGED.
To adjust the cupholder size for various containers: pull tab out to unlock, insert container, slide
cupholder against container, push tab in to lock position.