Warning – Gamber-Johnson 7160-0301 User Manual
Page 2

6. Install the Top Plate using (6) .38-16 bolts
and washers supplied in hardware bag.
Adjust Back Legs so Top Plate is aligned
with center of vehicle.
Tighten all nuts and drivers side seat bolts.
Reinstall trim pieces on rear drivers seat
brackets.
WARNING
• The components added to the Ford Super Duty Leg Kit should not be positioned in the area where the airbag
may be deployed if it is activated.
•
DO NOT position the equipment in front of an airbag. Equipment positioned in front of an airbag may cause
serious injury or death if an airbag is activated.
•
High speed vehicle turns may cause the moving parts of the assembly to swivel, interfering with the driver or
other equipment.
•
If installation of the equipment requires that the equipment be placed in front of an airbag, the airbag should be
deactivated. In order to secure permission for deactivating the airbag you must contact the National Highway
Traffic Safety Administration at 1-800-424-9393. If you have any questions or need assistance, call
Gamber-Johnson at 1-800-456-6868.
7. Install Workstation and other
equipment to the Top Plate as required.
Complete the install by reinstalling the
passenger seat.
2/2
4. Attach the Front Leg to studs which mounted
the front of the center seat/console section.
Place the Front Leg as shown with the bent edge
toward the front of the vehicle.
5. Slide one of the Back Legs under the
rear drivers seat bracket, reinstall seat bolt
but do not tighten.
Temporarily attach the other Back Leg using
the rear Passenger Seat Bolt, but do not tighten.
On vehicles with studs to mount the center
seat/console section reinstall the nuts,
but do not tighten.