Gamber-Johnson 7160-0413 - Manual

Rev.B
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
PS-001 FORD NGPI LEG KIT, 2012+
INSTALLATION INSTRUCTIONS
Product Revision
PEM nuts
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Printing Spec: Description
7160-0413
Form
Remove the stock tunnel plate by removing the 6 bolts. Note that in the Utility
Intercepter the lower portion of the dash will need to be removed in order to access
the front mounting bolts.
Install the two brackets as shown in figure 1 with the hardware removed from the
stock tunnel plate. The rear bracket will be installed with the shorter bolts removed
from the center of the stock tunnel plate.
Once the leg kit is installed the top plate (not included) can be bolted to the supplied
INST-566
Note:
If there is no factory front console plate(Top Plate) installed, use hardware bag
7120-0630(included) for required hardware
Fig. 1 - Leg Kit Orientation
Front Bracket
Rear Bracket
Front of Vehicle
Top Plate
Mounting PEMS
© copyright 2011 Gamber-Johnson, LLC