Gamber-Johnson 7160-0220 - Manual (Page 2)

2/2
Highway Traffic Safety Administration at 1-800-424-9393 to gain permission to do so. If you
secure permission for deactivating the airbag in these circumstances, contact the National
deactivate the airbag in the vehicle so it cannot be activated in an accident. In order to
•If installation of the equipment requires that the equipment be placed in front of an airbag,
death if an airbag was activated, such as in an accident.
in front of an airbag. Equipment positioned in front of an airbag can cause serious injury or
the area where the airbag will be deployed if it is activated. DO NOT position the equipment
•The Mongoose Locking Slide Arm and upper level equipment should not be positioned in
have any questions or need assistance, call Gamber-Johnson at 1-800-456-6868.
How to use the Mongoose Locking Slide Arm:
The Mongoose Locking Slide Arm is designed to accommodate four motions of
adjustment. The first being a 360 degree swivel that is actuated by the front lever. Pulling
out on the lever releases the gear latch located in the base and allows the mount to
swivel. To latch the arm in place, position the arm in the desired location and release the
spring loaded lever. Wiggle the arm back and forth to make sure the lever has engaged
the teeth on the gear.
The second motion is the slide. To actuate the slide, pull out and hold the spring
loaded pin. Pull the mount along the slide a minimum of 1/2" before releasing the pin to
ensure the mount does not latch back in the stowed position. Once you have released
the pin, pull forward on the mount until it is located in the desired position. The third
motion is the clevis swivel. The clevis can swivel 360 degrees for assembly 7160-0220. The
fourth motion is the clevis tilt. The amount of clevis tilt will depend on the type of
Mongoose Locking Slide Arm that was purchased. 7160-0220 tilts in one direction. 7160-
0220 comes complete with a 360 degree 0-90 type Clevis.
Note: Do not use this product if either latch mechanism is disabled or missing. The
product should be out of the airbag zone with the slide in the latched position when the
vehicle is in use.
7160-0220
(360) 0-120 Clevis
(supplied attached)
WARNING