Gamber-Johnson 7160-0384 - Manual

INSTALLATION INSTRUCTIONS
Product Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Rev.A INST-547
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2011 Gamber-Johnson, LLC
Printing Spec: PS-001 DISPLAY MOUNT ASSEMBLY
7160-0384
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
The Display Mount Assemembly is a clam shell type mount designed for light
weight displays. The Display Mount can hold displays that use either the
AMPs or NEC hole plattern.
Disassemble the Display Swivel from the mount and attach the customer
supplied display using the screws provided with the display. Reattach the
Display Swivel to the mount and tighten the 3/8" nut so the friction bearings are
holding the display in a stationary prosition.
The Base Swivel can be mounted to a flat surface with the 1/4" x 1" long
carriage bolts, flat washers, and nylok hex nuts supplied in the hardware bag.
Display
Display Swivel
Display mounting
screws
Friction Bearing
Friction Bearing
Backing Plate
Washer
3/8" lock nut
Base Swivel