Gamber-Johnson 7160-0419 User Manual

Installation instructions, Product form revision, Clevis

Rev.C

INST-585

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

Printing Spec:

7160-0419

INSTALLATION INSTRUCTIONS

PS-001

Product

Form

Revision

CLEVIS

INSTALL ON RIGID FLAT SURFACE

Drill two 0.261(G drill) inch diameter holes spaced 2 inches apart in desired

1.
location. Pay attention to orient holes such that Clevis is mounted in required
position.
2. Remove 1/4-20 Lock Nuts (item 1) and Washers (item 2) from Clevis.
3. Place Clevis on surface with Studs (item 3) going through holes.
4. Install Washers (item 2) and 1/4-20 Lock Nuts (item 1) on Studs (item 3) and
tighten to secure Clevis.

Position Clevis as desired and tighten 1/4-20 Lock Nuts (item 1) securly locking

Clevis into position.

loosely tighten.

FOR DESIRED SWIVEL TENSION

INSTALL ON EQUIPMENT WITH GAMBER JOHNSON SWIVEL PATTERN CUTOUT

Remove 1/4-20 Lock Nuts (item 1) and Washers (item 2) from Clevis.

Place Clevis on equipment with Studs (item 3) going through curved slots.

Install Washers (item 2) and 1/4-20 Lock Nuts (item 1) on Studs (item 3) and

TIGHTEN OR LOOSEN NUT