Figure 1. figure 2 – Gamber-Johnson 7160-0502 User Manual
Page 2
CENTER UPPER BOTTOM
CENTER UPPER TOP
FLAT WASHERS
1/4" BOLTS AND
AND NYLOK NUTS
1/4" FLAT WASHERS
1/4-20UNC STUDS
2/3
Figure 1.
Figure 2.
Attaching an Angled Low Swivel to the 6" Locking Arm
To attach an Angled Low Swivel, remove the Nylok Nut, Steel Bearing Backup Plate, the
Top Nylon Bearing, and the supplied 0-90° Clevis from the assembly. Place the Angled Low Swivel
onto the 3/8" stud so it rests on the Bottom Nylon Bearing. Attach the Angled Low Swivel in place
with the Top Nylon Bearing, Steel Bearing Backup Plate, and the Nylock Nut that were removed
when you first removed the bearings from the original clevis configuration. Tighten the Nylok Nut
until the desired friction is obtained for the rotation of the Angled Low Swivel. (See Figure 2)