Gamber-Johnson 7160-0532 - Manual (Page 2)

Remove Front Passenger Seat:
Slide the seat forward and remove the rear seat bolts with a T50 bit. See Figure1. 1.
Slide seat backward, now lean seat forward and slide out of the front hook slots, and set 2.
seat out of the way.
Install Vehicle Base:
Set vehicle base in place to allow seat hooks to slide through the rectangular slots in the 1.
base. See Figure 2.
Hook seat back into slots. 2.
Install T-Brackets using provided hardware. The tab of the bracket will be between the 3.
vehicle base and the seat rail. See Figure 3.
Slide seat forward and replace rear seat bolts. 4.
Attach the DS-Step with the hardware provided. See Figure 4. 5.
Figure 1.
Figure 3. Figure 4.
Figure 2.
NOTES:
If additional stability is required, use the optional floor bolt holes. Before drilling the holes 1.
ensure the area underneath the floor is clear.
2. Vehicle with power seats: rise the seat above for maximum seat travel.