Gamber-Johnson 7160-0527 - Manual (Page 2)

driver or other equipment.
Remove the front two bolts of the front passenger seat using T-40 bit. See Figure 1. 1.
Lossen the rear seat bolts of the front passenger seat using T-40 bit. See Figure 2. 2.
Slide the base between the seat rail and seat base. See Figure 3. 3.
Replace the front bolts and tighten them.
NOTES:
This vehicle base works only with the bucket seats model. 1.
5.
Figure 1.
4.
Figure 2.
Retighten the rear bolts.
Install Vehicle Base:
•This assembly should not be positioned in the area where the airbag may be deployed.
•DO NOT position the equipment in front of an airbag. Equipment positioned in front of an
airbag may cause serious injury or death if an airbag is activated.
•If installation of the equipment requires that the equipment be placed in front of an airbag,
the airbag should be deactivated. In order to secure permission for deactivating the airbag
you must contact the National Highway Traffic Safety Administration at 1-800-424-9393 to
gain permission to do so. If you have any questions or need assistance, call Gamber-Johnson
at 1-800-456-6868.
•High speed vehicle turns may cause parts of the assembly to swivel, interfering with the
Figure 3.