Gamber-Johnson 7160-0544 - Manual (Page 3)

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
Caution: Check for what is underneath the vehicle floor before drilling
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
into the vehicle.
INSTALLATION INSTRUCTIONS:
Remove in-bound seat bolts and loosen the out-bound seat bolts of the 1.
passenger seat using M6 allen wrench.
Lift the seat up and slide the Base between the seat and the floor. 2.
Install the in-bound seat bolts and tighten all the 4 seat bolts. 3.
Now using the hardware provided, mount the Riser to the Base. 4.
A Support Brace (not provided) could be installed using the mounting 5.
holes (see Figure 1) on the base. This requires 1/4-20 bolt (not provided).
Optional: Install 1/4-20 bolts (not included) in the vehicle base for 6.
additional support. This require drilling holes into the vehicle.
NOTE:
This vehicle base would not work with a bench seat (60-40 seat)
© Copyright 2014 Gamber-Johnson, LLC