Gamber-Johnson 7160-0545 User Manual

Page 3

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications

and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.

If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868

into the vehicle.

Caution: Check for what is underneath the vehicle floor before drilling

This Leg Kit would not work with a bench seat (60-40 seat)

INSTALLATION INSTRUCTIONS:

Remove in-bound seat bolts and loosen the out-bound seat bolts of

both driver and passenger seat using M6 allen wrench.

Lift the seat up and slide the Legs between the seats and the floor.

Install the in-bound seat bolts. Do not tighten the seat bolts, this would

allow some flexibility during installing the Unistruts.

Now using the hardware provided, mount the Unistruts to the Leg kit.

Use Position A or Position B to mount the Unistrut depending on how

back you want the console box/work station (See Figure 2.)

Tighten all seat bolts using M6 allen wrench.

Optional: Install 1/4-20 bolts (not included) in the Leg for additional

support. This require drilling holes into the vehicle.

NOTE:

Figure 2.

Position A

Position B

2.00

10.00