Gamber-Johnson 7160-0248 - Manual (Page 2)

WARNING
•The 7160-0248 Assembly should not be positioned in the area where the airbag may be
deployed.
•DO NOT position the equipment in front of an airbag. Equipment positioned in front of an
airbag may cause serious injury or death if an airbag is activated.
•
If installation of the equipment requires that the equipment be placed in front of an airbag,
the airbag should be deactivated. In order to secure permission for deactivating the airbag
you must contact the National Highway Traffic Safety Administration at 1-800-424-9393 to
gain permission to do so. If you have any questions or need assistance, call
Gamber-Johnson at 1-800-456-6868.
•
High speed vehicle turns may cause parts of the assembly to swivel, interfering with the
driver or other equipment.
9. Pull base pole away from the passenger seat, extend brace against seat base
and tighten the two brace screws.
10. Install upper pole, motion attachment and docks/cradle per the instructions
supplied with those products.
2/2
6. Removing backing and apply pad to brace. If attaching with screw, pierce a hole
in the pad after adhering.
7. Replace seat and tighten nuts securing it in the vehicle. Make sure the Seat
Adjustment Handle clears the mount before moving the seat forward.
8. If desired, attach brace to seat frame with customer supplied hardware.
Fig 1
Fig 2