Gamber-Johnson 7160-0512 User Manual
Page 2
Remove Front Passenger Seat:
Remove the plastic trim pieces from the passenger seat that cover the front hooks, rear
1.
seat bolts, and the side of the seat. See Figure 1.
Remove the rear seat bolts with a T50 bit.
2.
Disconnect the yellow cable connector assembly fom the side of the seat under the seat
3.
rail. See Figure 2.
Lean seat forward and slide out of the front hook slots, and set seat out of the way.
4.
Install Vehicle Base:
Set vehicle base in place to allow seat hooks to slide through the large holes in the base.
1.
See Figure 3.
Hook seat back into slots. See figure 4.
2.
Replace rear seat bolts.
3.
Install T-Brackets using provided hardware. The tab of the bracket will be between the
4.
vehicle base and the seat rail. See Figure 5.
Attache the DS-Step with the hardware provided.
5.
Plug in the yellow cable assembly that was disconnected earlier.
6.
The trim will not fit with base installed. It could be modified to fit or left off. (Up to
7.
cusomer)
Figure 1.
Figure 2.
Figure 3.
Figure 4.
Figure 5.