Gamber-Johnson 7160-0342 - Manual (Page 2)

WARNING
•The 7160-0329 assembly should not be positioned in the area where the airbag may be
deployed.
•DO NOT position the equipment in front of an airbag. Equipment positioned in front of an airbag
may cause serious injury or death if an airbag is activated.
•
If installation of the equipment requires that the equipment be placed in front of an airbag,
the airbag should be deactivated. In order to secure permission for deactivating the airbag
you must contact the National Highway Traffic Safety Administration at 1-800-424-9393 to
gain permission to do so. If you have any questions or need assistance, call
Gamber-Johnson at 1-800-456-6868.
•
High speed vehicle turns may cause parts of the assembly to swivel, interfering with the
driver or other equipment.
3/8-16 x .75 HARDWARE
PROVIDED IN HARDWARE BAG
Optional:
The use of a support brace (7160-0230) is recommended to support the assembly. A
recommended installation is shown below using factory hardware on the passenger
seat.
USE EXISTING HARDWARE
BEND END OF BRACE AS REQUIRED