Feiss WB1451 User Manual

Wb1451, Assembly instructions for

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before

assembly. Bulbs

not included.

1. Install large glass plate:

Install large glass panel onto rear of fixture frame by bending

tabs.

2. Install anchor (included):

A. Hold mounting plate up against the wall aligning the two

holes in the wall outlet box with appropriate slots in the

mounting plate. Then while the mounting plate is leveled

vertically, use a pen or pencil to make a mark on the wall at

holes located near each end of mounting plate.

B. Remove the mounting plate and set aside.

C. Drill marked spots. If drywall or masonry wall then use

1/4" (7 mm) drill bit; if wood wall then use 1/8" (4 mm) drill

bit.

D. Drywall or masonry wall only: Insert plastic anchor into

pre-drilled holes.

3. Install mounting plate:

A. Take supply wires from outlet box and carefully pass them

through center hole of mounting plate. Note: the flat surface

of mounting plate must face the wall and the angled rim side

facing toward you.

B. Install mounting plate to outlet box using two screws

supplied with the outlet box.

C. Secure mounting plate onto pre-drilled holes using sheet

metal screws (included).

D. Then Spread electrical wires so that black wires are on

one side of the outlet box and the white wires are on the

other side.

4. Connect electrical wires:

A. Connect white fixture wire(s) to white supply wire from

outlet box with wire connector. Connect black fixture

wire(s) to black supply wire from outlet box with wire

connector.

NOTE: Black outlet box wire may be red, round and smooth

and/or have copper conductor. White outlet box wire may

be square and ridged and/or have a silver conductor.

B. Connect fixture ground wire (without plastic insulation)

to ground wire from outlet box (usually with green

insulation) with wire connector.

Note: If there is no supply ground wire at outlet box then

attach fixture ground wire securely onto green grounding

screw located at mounting plate.

IMPORTANT: Never connect ground wire to black or white

supply wires (from outlet box).

5. Install fixture:

A. Hook top of fixture frame onto top edge of mounting

plate.

B. Then secure fixture frame onto bottom of mounting plate

by fastening set screws. Use provided hex key to tighten.

6. Install bulb:

A. Rotate housing until inside socket is exposed.

B. Install type T-10 of medium base light bulb (not included).

IMPORTANT: See relamping label at socket area for

maximum allowed wattage.

C. Install small glass plate by sliding inside of housing.

D. Rotate housing to desired position. Note: You have the

option to either direct or indirect light by turning the

housing accordingly.

Warning: Shade becomes HOT. Do not rotate shade while

fixture is lit. Turn off and allow shade to cool before rotating

into desired position.

Assembly Instructions For

WB1451

(E) 5/09