Feiss VS4200_ User Manual
Aveline 3 and 4 light vanity strip, Installation instructions for, Vs4200
1
Installation Instructions for
Aveline 3 and 4 Light Vanity Strip
1.0
VS4200_
VS4200_
Secure the mounting plate to the electrical box with the two mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Install the candle tube by slipping through socket.
Place the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Install the shade by properly placing it over the lamp.
If necessary, repeat steps 6-8 for remaining shades.
Install the decorative strands by hooking them to the fixture.
1
2
3
1A
LAMP
SHADE
CANDLE TUBE
6
4
HOT WIRE
BLACK WIRE
ELECTRICAL BOX
MOUNTING
PLATE
MOUNTING
PLATE SCREW
WHITE WIRE
1
1
5
6
7
8
FIXTURE
SCREW
5
Wall
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized
esting aboratory”
N
R
T
L
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SOCKET
DECORATIVE STRAND
ALLEN WRENCH
7
9
8
10
10
10
NEUTRAL WIRE