Feiss VS53003 - Manual

1
Installation Instructions for
Align the anchors with the mounting plate holes and install them by pushing them into the wall.
Secure the mounting plate to the electrical box with two mounting plate screws.
Screw the anchor screws into the anchors.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, mount the fixture base onto the mounting plate, and secure it with the fixture
screws using an Allen wrench.
Screw the finial to the bottom of the fixture.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Install the shade by properly placing it over the socket and secure it in place by mounting it onto the corresponding fixture hook.
Repeat steps 8-10 for remaining sockets.
1
2
3
1A
LAMP
4
HOT WIRE
BLACK WIRE
ELECTRICAL BOX
MOUNTING
PLATE
NEUTRAL WIRE
WHITE WIRE
2
2
5
6
7
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SOCKET
SHADE
7
FIXTURE SCREW
9
10
7
8
8
FINIAL
Monica 2 and 3 Light Vanity Strip
1.1
VS53002-VS53003
V 53002, V 53003_ S S
Vanity Strip
HOOK
ANCHOR
SCREW
ANCHOR
9
10
ALLEN WRENCH
1
3
MOUNTING
PLATE SCREW