Feiss VS49002 - Manual

1
Installation Instructions for
Payne 1 and 2 Light Vanity Strip
1.1
VS48001-VS48002-VS49001-VS49002
V 48001,V 48002, S S
V 49001,VS49002_ S
Secure the mounting plate to the electrical box with the two mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Screw the lamp(s) into the socket. Refer to the label on the lamp socket for Max Wattage information.
Install the shade by screwing it into the shade base. If necessary, repeat steps 6 and 7 for remaining socket.
1
2
3
1A
LAMP
4
HOT WIRE
BLACK WIRE
ELECTRICAL BOX
MOUNTING
PLATE
NEUTRAL WIRE
WHITE WIRE
1
1
5
6
5
Wall
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SHADE BASE
MOUNTING
PLATE SCREW
SHADE
7
FIXTURE SCREW
ALLEN WRENCH
6
7