Feiss VS44004 - Manual

1
Installation Instructions for
Huntley 1, 2, 3, and 4 Light Vanity Strip
1.1
V 4400_ S
V 44001, V 44002, S S
V 44003 V 44004_ S S
Secure the mounting plate to the electrical box with the two provided mounting plate screws (install anchors provided
with larger models for additional support).
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Place the shade and spacer over the socket, then secure them in place by tightening the collar nut using the shade tool;
repeat for remaining sockets.
Screw the lamp(s) into the socket(s). Refer to the label on the lamp socket for Max Wattage information.
1
2
3
1A
LAMP
4
HOT WIRE
BLACK WIRE
ELECTRICAL BOX
MOUNTING
PLATE
NEUTRAL WIRE
WHITE WIRE
1
1
5
6
FIXTURE SCREW
5
Wall
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SOCKET
ALLEN WRENCH
MOUNTING
PLATE SCREW
SHADE
7
6
7
COLLAR NUT
SPACER
SHADE TOOL