Feiss WB1732 User Manual
Talia 1, 2, and 3 light vanity strip, Installation instructions for, Wall
1
Installation Instructions for
Talia 1, 2, and 3 Light Vanity Strip
1.0
VS50003-WB1731-WB1732
VS50003,WB1731,
WB1732_
Secure the mounting plate to the electrical box with the two mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws using an Allen wrench.
Screw the lamp(s) into the socket(s). Refer to the label on the lamp socket for Max Wattage information.
Install the shade by carefully sliding it into the fixture brackets and using the shade screws to secure it in place.
Install the endcaps to the ends of the fixture and secure them in place using the endcap screws.
1
2
3
1A
4
5
6
Wall
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized
esting aboratory”
N
R
T
L
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
7
FIXTURE SCREW
ALLEN WRENCH
HOT WIRE
BLACK WIRE
ELECTRICAL BOX
MOUNTING
PLATE
NEUTRAL WIRE
WHITE WIRE
1
1
MOUNTING
PLATE SCREW
SHADE
LAMP
FIXTURE
ENDCAP
ENDCAP
SCREW
SHADE SCREW
8
5
6
7
8
8