Feiss OL6001 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulbs not included.
1. A. Install a hex nut onto one end of threaded pipe leaving
about 3/8" (10 mm) thread exposed.
B. Screw same end of threaded pipe into coupler. Tighten
hex nut.
C. Slide font through threaded pipe until checks onto
roof. Lock them into position by fastening with rubber
washer and finial.
2. Follow enclosed supplement installation instructions for
electrical and fixture installation onto house outlet box. If
you do not have an outlet box at desired location to
attach the fixture than hire a qualified electrician to create
one.
3. Install bulb (not included). See relamping label located near
socket area for type and maximum allowed wattage.
4. Gently place glass shade inside of main frame.
5. Install main frame onto roof by fastening with ball cap nuts
onto the two protruding threaded studs.
6. Install finial by screwing onto coupler.
Assembly Instructions For
OL6001
(E) 10/07
Coupler
Coupler
Main Frame
Threaded Pipe
Shade
Finial (small)
Rubber Washer
Font
Fixture Plate
Cap Nut
Bulb (not included)
1
2
3
4
5
6
Finial