Feiss OL8107 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulb not included.
1. Electrical installation onto post (not
supplied): If you are replacing an existing
fixture, disconnect and remove the old
fixture.
A) Slip post cup over post. Mark position of
holes in post cup on post.
B) Remove post cup and expose the supply wiring
from above post. Drill and tap a screw hole for
the provided screw.
C) Connect white fixture wire to white supply wire
from post with wire connector. Connect black
fixture wire to black supply wire from post with
wire connector.
NOTE: Black wire from post may be red, round
and smooth and/or have copper conductor. White
wire from post may be square and ridged and/or
have a silver conductor.
D) Connect fixture ground wire (without plastic
insulation) to ground wire from post (usually with
green insulation) with wire connector.
IMPORTANT: Never connect ground wire to black
or white supply wires.
E) Tuck all wires inside of post.
F) Slip post cup onto post. Align holes in post cup
with holes in post. Secure them together by
fastening with machine screws (enclosed).
2. Install light bulb (not included). See
relamping label at socket area for type and
maximum allowed wattage.
3. Install the bottom cover onto the main frame
and fasten with screws.
4. Install the fixture loop on top of the cover.
Assembly Instructions For
2
3
4
OL8107
(E) 12/11
1F
1C
1A
1D
1B