Feiss OL7607 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs not
included.
1. A. Slip candle tube over sockets.
B. Install type-B, candelabra base, of 60 Watt maximum bulbs (not
included).
2. A. Install center pipe by screwing at center of socket assembly.
B. Slip cover and rubber washer through center pipe.
C. Slip upper assembly through the center pipe. Then secure all
together by slipping another rubber washer and fastening with finial.
3. Electrical installation onto post: If you are replacing an existing
fixture, disconnect and remove the old fixture.
A) Slip post cup over post. Mark position of holes in post cup on
post.
B) Remove post cup and expose the supply wiring from above post.
Drill 1/8" (3mm) diameter pilot holes in post at places where
marked.
C) Connect white fixture wire to white supply wire from post with
wire connector. Connect black fixture wire to black supply wire from
post with wire connector.
NOTE: Black wire from post may be red, round and smooth and/or
have copper conductor. White wire from post may be square and
ridged and/or have a silver conductor.
D) Connect fixture ground wire (without plastic insulation) to
ground wire from post (usually with green insulation) with wire
connector.
IMPORTANT: Never connect ground wire to black or white supply
wires.
E) Tuck all wires inside of post.
F) Slip post cup onto post. Align holes in post cup with holes in post.
Secure them together by fastening with sheet metal screws
(enclosed).
Assembly Instructions For
OL7607
(E) 11/09
3F
3D
3A
3C
3B
1A
1B
2A
2B
2C