Feiss OL1013 - Manual

10/99
A
SSEMBLY
I
NSTRUCTIONS
F
OR
OL-1013
M U R R A Y F E I S S
©FEISS INDUSTRIES
Outlet Box
Ceiling
Mounting Strap
Hex Nut
Glass Housing
Coupler
Long Threaded Pipe
Cap
Finial
Outlet Box Mouting Screws
Ground
Wire
6. To make electrical connections: Connect the white
wire(s) from the fixture to the white wire of the outlet
box. Connect the black wire(s) from the fixture to the
black wire of the outlet box. NOTE: Black outlet box
wire may be red, round & smooth and/or have copper
conductor. White outlet box wire may be square &
ridged and/or have a silver conductor.
7. Place pan thru short threaded pipe so pan sits
flush against ceiling. Be sure all wires are inside
pan. Secure pan to ceiling by fastening coupler
onto short threaded pipe. Coupler must turn at least 3
times, if it does not you must lengthen threaded pipe
accordingly.
8 Bulb Fixture: Refer to relamping label found in pan for
correct wattages.
9. Screw long threaded pipe into coupler until secure.
Place glass housing over pan. Secure cap with finial.
1. If your are replacing an existing fixture, disconnect and
remove the old fixture. Expose the supply wiring from
the outlet box.
2. Screw short threaded pipe 3 complete turns into the
mounting strap and lock in place with hex nut.
3. Fasten the mounting strap to the outlet box using the
two screws supplied with the outlet box.
4. Spread the electrical wires so that the black wires are on
one side of the outlet box and the white wires are on the
other side.
5. Mounting strap is provided with a green ground wire
attached. Connect mounting strap ground wire to
ground wire from outlet box wire with wire connector
(not provided).
Never connect ground wire to black or white power supply
wires
IMPORTANT
T
URN
O
FF
T
HE
P
OWER AT THE
M
AIN
F
USE OR
C
IRCUIT
B
REAKER
B
OX
B
EFORE
S
TARTING
I
NSTALLATION
Short Threaded Pipe
Pan