Feiss P1113 - Manual

(E) 4/07
ASSEMBLY INSTRUCTIONS FOR P1113
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Bulb
(not included)
Canopy
(Fixture Plate)
Shade
Carefully unpack and identify all parts before assembly.
Bulbs are not included.
1. Install stems:
A. Choose desired installation height from any
combination of stems provided. Additional stems can
be purchased to increase installation height. However
do not add more stems than will allow 6" (15 cm) of
fixture wires above fixture plate.
B. Thread fixture wires through a center pipe. Install
center pipe by screwing into coupler.
C. Slip square stem through the installed center pipe.
Note correct position of stem from left diagram.
D. Lock stem into position by fastening with a lock
washer and coupler onto protruding center pipe. Note:
make certain center pipe is protruding about 3/8" (10
mm) above stem. If not then twist center pipe to loosen
in order to increase to desired height.
E. Repeat above steps B - D for additional stems.
F. For flat ceiling: After final stem installation, install
fixture plate on top of stem by fastening with lock
washer and hex nut onto protruding center pipe.
For vaulted ceiling (kit included in hardware bag):
After final stem installation, install hook on top of stem
by screwing onto protruding center pipe. Install short
threaded pipe into loop. Install loop onto bottom of
fixture plate by fastening with lock washer and hex nut
from above. Thread fixture wires through installed loop
center hole. Then while pulling wires from above,
attach hook onto loop.
2. Measure 6" of wire from end of fixture plate and cut off
remaining wire. Split wires and strip off 3/4" of
insulation from each end.
3. Follow enclosed "Multiple Standard Installation
Instructions" for electrical and fixture installation onto
ceiling junction box.
4. Place Shade over threaded socket then spacer tube and
secure with counter ring, using supplied wrench.
5. Install bulbs (not included). See relamping label located
at socket area for type and maximum allowed wattage.
Counter Ring
Socket
Fixture Wires
& Ground Wire
Hex Nut
Lock Washer
Ball Cap Nut
Short
Threaded
Pipe
Canopy
Loop
Hook
Stem
VAULTED CEILING
INSTALLATION
Center Pipe
Coupler
Coupler
Square Stems
(3) 12 in. long
(1) 6 in. long
Lock
Washer
Spacer Tube
Wrench
(included)