Feiss P1301 - Manual

1
Installation Instructions for
Payne 1 Light Pendant
1.0
P1300-P1301
Pendant
P1300, P1301_
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for dry locations only.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
Determine the height of the fixture with the provided stems and assemble them by screwing them together.
Secure the mounting plate to the electrical box with two mounting plate screws.
Feed the fixture wires through the stems and screw the stem assembly to the socket assembly.
Feed the fixture wires through the canopy and screw the canopy onto the stem assembly.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, place the canopy onto the mounting plate, and secure it in place by
screwing in the fixture screws with an Allen wrench.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Install the shade to the socket assembly by screwing it in.
1
2
1A
LAMP
6
SOCKET ASSEMBLY
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SHADE
1
2
ALLEN
WRENCH
FIXTURE
SCREW
3
4
5
9
4
3
MOUNTING
PLATE
CANOPY
STEM
ASSEMBLY
6
7
8
9
10
1
7
8
10