Feiss P1328 - Manual

1
Installation Instructions for
Lumiere' 1 Light Pendant
1.0
P1328
Pendant
P1328_
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for dry locations only.
This instruction shows a typical installation.
Secure the mounting plate to the electrical box with two mounting plate screws.
Temporarily remove the socket assembly from the fixture by removing the screws from the inside of the fixture.
Install the glass panels by carefully sliding them into the fixture.
Reinstall the socket assembly by screwing in the screws from the inside of the fixture.
Determine the wanted height of the fixture and remove a portion of the chain by opening a link with pliers.
Install a quick link onto the chain and fixture loop, then install another quick link to the other end of the chain and canopy loop.
Weave the cord through the chain, canopy, and out of the electrical box. Trim the cord leaving enough to make electrical
connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, place the canopy onto the mounting plate, and secure it in place by screwing in
the fixture screws.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
1
2
1A
FIXTURE
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
3
4
5
12
6
7
8
LAMP
9
10
GLASS PANEL
SCREW
SOCKET
ASSEMBLY
2
QUICK LINK
FIXTURE
2
9
6
FIXTURE
SCREW
MOUNTING
PLATE
CANOPY
10
11
CHAIN
CANOPY
LOOP
6
FIXTURE
LOOP
11
12