Feiss P1137 User Manual

P1137, Assembly instructions for

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before

assembly.

Bulb not included.

1. Install stems:

A. Choose desired installation height from dimensions shown in

above diagram. Thread fixture wires through each stems to be

used. Note correct position of stems from left diagram. Screw all

stem together until secure.

B. Pass fixture wires through swivel in canopy and screw top end

of stem assembly into swivel.

2. Follow enclosed supplement installation instructions for electrical

and fixture installation onto house outlet box. If you do not have

an outlet box at desired location to attach the fixture than hire a

qualified electrician to create one.

3. A. Install bulb (not included). See relamping label located near

socket area for type and maximum allowed wattage.

NOTE: Make certain not to handle lamp with bare hand since this

will cause lamp to shatter at high heat. Handle with clean soft

cloth.

B. Install glass dome by screwing onto socket.

4. Install harp by securely fastening with thumb screws.

5. A. Place metal ring onto glass plate. Then place shade. And then

place another ring on top of shade.

B. While holding firmly onto glass plate, install the assembled

parts onto harp by fastening with finial.

Assembly Instructions For

P1137

Socket

Bulb

(not included)

Glass Dome

Stems

Shade

Canopy

(Fixture Plate)

Cap Nuts

(E) 4/08

Swivel

Glass Plate

Thumb Screw

Metal Ring

Harp

Finial

50-1/4"

38-1/4"

44-1/4"

32-1/4"

20-1/4"

26-1/4"

8-1/4"

14-1/4"