Feiss F2817-10 - Manual

Installation Instructions for
Celebration 10 Light Chandelier
1.0
F2817-10
CAUTION - RISK OF FIRE
This product requires installation by a qualified electrician.
Before installing be sure to read all instructions and
TURN THE POWER TO THE ELECTRICAL BOX OFF.
Chandelier
F2817_
G P I : ENERAL RODUCT NFORMATION
This product is suitable for dry locations only.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
1A
Secure the mounting plate to electrical box with the two provided mounting plate screws.
Install anchors to the ceiling and secure the mounting plate with the two provided anchor screws.
Determine the height of the fixture with provided stems and assemble them by screwing them together.
NOTE: After stems have been screwed to canopy, ensure canopy hex nuts are tightened.
Mount and secure the fixture to the stems.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Feed the fixture wires through the stem, then secure the canopy to the mounting plate rods with the provided ball nuts
(will need assistance).
Install candle tube by slipping through socket.
Insert the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Place and secure shade in shade holder.
1
2
3
4
5
SHADE
LAMP
SHADE
HOLDER
CANDLE TUBE
STEM
ASSEMBLY
3 3
10
9
11
11
1
5
2
6
7
8
9
NEUTRAL WIRE
WHITE WIRE
HOT WIRE
BLACK WIRE
MOUNTING PLATE
ANCHOR
ANCHOR SCREW
1
2
10
6 7
BALL NUT
8
ROD
8
FIXTURE
11
4 4
1
CANOPY