Feiss F2478 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulbs not included.
1. Turn arms so they are equally spaced apart from each
other.
2. A. Slip small notched cover and fixture loop through
fixture wires.
B. Install the small notched cover on top of fixture,
making certain arms are locked onto it’s notches, by
fastening with fixture loop.
C. Install a hex nut onto one end of short threaded
pipe leaving about 3/8” (10mm) of thread exposed. Then
install same end of pipe by screwing onto bottom of
fixture. Tighten hex nut.
D. Slip large notched cover through the installed
threaded pipe and secure by fastening with finial. Make
certain arms are locked onto it’s notches before
tightening finial.
3. Follow enclosed supplement installation instructions for
electrical and fixture installation onto house outlet box.
If you do not have an outlet box at desired location to
attach the fixture then hire a qualified electrician to
create one.
IMPORTANT: WHEN FOLLOWING SUPPLEMENT
INSTRUCTIONS STEP #6, MAKE CERTAIN TO SLIDE
CRYSTAL BOBECHE (IN BETWEEN COLLAR RING
AND CANOPY) DOWN THE CHAIN. See above
illustration.
4. A. Install crystal bobeche by slipping through sockets.
B. Install candle tube by slipping through sockets.
C. Install type-B, candelabra base, of 60 Watt maximum
bulbs (not included).
5. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystal or pin, extras are
included in hardware bag. Replace by gently bending
open pin, remove broken crystal or pin, hook new one,
then close back pin. Avoid bending pin into sharp angle.
Assembly Instructions For
F2478/6
(E) 11/09
2 3
9
6
7
6
8
6
5
4
1
1
X6 X3 X3 X7 Required
Extra 1 1
2 1 3 4
X6 X24 X6 X1 X6
1 1 1 6 1
9 8 7
12 bead
6 5
PIN
PART
S Hook
Head Pin
Bowtie pin
PIN
DESCRIPTION
6
6
12
Extra
PIN Qty.
Candle
Tube
Bulb (not included)
Small Notched Cover
Short Threaded Pipe
Large Notched Cover
Finial
Fixture Loop
Arm