Feiss F1919-6+1 - Manual

Fixture Wire
& Ground Wire
Fixture Loop
Notched Cover
Short Threaded Pipe
Coupler
Extension Arms
Upper
Center
Body
Bulb G-16-1/2
(Not included)
Bulb (Not included)
Cover
Counter
Ring
Socket
Ring
Center
Glass
Shade
Cage
(E) 10/04
ASSEMBLY INSTRUCTIONS FOR F1919/6+1
M U R R A Y F E I S S
©MURRAY FEISS IMPORT LLC.
Lower
Center Body
Center Socket
Arm
Machine Screw
Hex Key
Plate
Lock Washer
Coupler
Font
IMPORTANT:
TURN OFF THE POWER AT THE
MAIN FUSE OR CIRCUIT BREAKER
BOX BEFORE STARTING
INSTALLATION
Carefully unpack and identify all parts
before assembly. Bulbs are not included.
1. Sit center cage and then center glass shade
gently onto center socket. Lock them
together by fastening with ring and
counter ring. Do not yet install cover.
2. Install arms:
A. Remove coupler located below lower
center body. And then slide out lock
washer and plate. Set them aside.
B. Spread open arms so they are evenly
spaced out to each other. Fasten lower
section of arms securely onto lower
center body with machine screws from
inside. Tighten them with enclosed hex key.
C. Install back the plate onto lower
center body by fastening with lock
washer and coupler.
D. Take fixture wires and ground wire,
exiting above upper center body, and
thread through short threaded pipe,
notched cover, and fixture loop.
Then screw short threaded pipe securely
into coupler. Slide notched cover through
short threaded pipe untill it’s notches
properly checks onto extension arms.
Then lock all together by fastening
fixture loop.
3. Follow enclosed “Chain Suspended
Fixture Installation Instructions” for
electrical and fixture installlation onto
ceiling outlet box.
4. Install a standard A-19 medium base of
100 Watt maximum bulb (not included)
into center socket.
5. Take the cover and gently glide through in
between arms. Then install it on top of cage.
6. Install side glass shade by sitting onto fitter.
Then install a G-16 1/2 candelabra base of
60 Watt maximum bulb (not included) into
socket. Repeat others.
7. Install font by screwing into coupler
located at lower center body.
Fitter
Side
Glass
Shade