Feiss F2475 User Manual
Assembly instructions for, E) 8/13
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT BREAKER
BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulbs
not included.
1. Turn arms so they are equally spaced apart from each other.
2. A. Slip small notched cover and fixture loop through fixture
wires.
B. Install the small notched cover on top of fixture, making
certain arms are locked onto It’s notches, by fastening with
fixture loop.
3. Install ring onto fixture by fastening with thumb screws from
behind of arms.
4. Follow enclosed supplement installation instructions for
electrical and fixture installation onto house outlet box. If you do
not have an outlet box at desired location to attach the fixture
than hire a qualified electrician to create one.
IMPORTANT: WHEN FOLLOWING SUPPLEMENT INSTRUCTIONS
STEP #6, MAKE CERTAIN TO SLIDE CRYSTAL BOBECHE (IN
BETWEEN COLLAR RING AND CANOPY) DOWN THE CHAIN. See
above illustration.
5. A. Install a hex nut onto one end of threaded pipe leaving about
3/8” (10mm) of thread exposed. Then install same end of pipe
by screwing onto bottom of fixture. Tighten hex nut.
B. Slip large notched cover through the installed threaded pipe
and secure by fastening with finial. Make certain arms are
locked onto it’s notches before tightening finial.
6. A. Install crystal bobeche by slipping through sockets.
B. Install candle tube by slipping through sockets.
C. Install candle follower onto top of candle follower
(for MBZ
finish only)
.
D. Install type-B, candelabra base, of 60 Watt maximum bulbs
(not included).
7. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystal or pin, extras are included in
hardware bag. Replace by gently bending open pin, remove
broken crystal or pin, hook new one, then close back pin. Avoid
bending pin into sharp angle.
Assembly Instructions For
F2475/6
Bulb
(not included)
(E) 8/13
Candle
Tube
Arm
Fixture Loop
Ring
Threaded Pipe
Large Notched Cover
Finial
Small
Notched Cover
Socket
Bobeche
Candle Follower
(Included with
MBZ finish only)
7
8
9
10
3
2
FACTORY
INSTALLED
X6
X6
X6
X18
X7
X6
Require
d
1
Extra
4
5
6
1
4
2
2
1
3
2
5
4
6
13 bead
14 bead
11 bead
X6
X1
X6
1
1
X3
1
1
8
9
7
10
12 bead
16 bead
Extra PIN
Qty.
24
12
12
Small Bead
Hook
Large
S Hook
Small
S Hook
PIN
DESCRIPTION
PIN PART