Feiss F2735-3 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulbs not included.
1. Slip fixture loop down through the fixture wires,
and then screw on top of fixture.
2. This fixture can be mounted onto ceiling either as
chain hung or flush mount:
CHAIN HUNG INSTALLATION:
A. Take fixture wire (with plastic insulation) and
ground wire and thread through fixture loop. Then
install loop onto threaded pipe located at top of
fixture.
B. This fixture is supplied with 2 threaded chain
links. These links are opened and closed by
twisting cylinder on chain link. One threaded chain
link should be installed onto canopy loop and the
other should be installed onto fixture loop. The
standard chain should be installed in between
these 2 threaded chain links.
C. Determine the desired length of chain to hang.
Remove any unwanted links with chain plier.
D. Take ground wire and weave through above
chain links, then thread through center hole in
canopy loop. Repeat with fixture wire (wire with
plastic insulation).
FLUSH MOUNT INSTALLATION:
A. Remove and discard canopy loop and threaded
pipe from fixture plate.
B. Thread ground wire and fixture wire through
fixture plate, lock washer, and hex nut. Lock all
together on top of fixture by tightening hex nut
onto threaded pipe.
3. Cut excess wires leaving only 6" (15cm) length of
wires above canopy. Split fixture wire into two
strands. Then strip off 3/4" (19mm) of outer
plastic insulation.
4. Follow enclosed supplement installation
instructions for electrical and fixture installation
onto house outlet box. If you do not have an outlet
box at desired location to attach the fixture then
hire a qualified electrician to create one.
5. Install the center column onto the threaded pipe.
6. Install the font onto the bottom of the fixture.
7. A. Install candle tube by slipping through sockets.
B. Install type-B, candelabra base, of 60 Watt
maximum bulbs (not included).
8. Hang all tassels as shown on drawing.
NOTE: To replace broken tassels, extras are
included in hardware bag. Replace by gently
bending open pin, remove broken pin, hook new
one, then close back pin. Avoid bending pin into
sharp angle.
Assembly Instructions For
7B
7A
2
2
6
4
8
5
3
1
Semi Flush Mount
Assembly
F2735/3
(E) 12/11