Feiss SF246 - Manual

(E) 10/07
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulbs not included.
1. Install Center Column by screwing securely into fixture
plate.
2. A. Take one arm and insert bottom section of arm into
a hole in center plate. Then fasten top section of arm
onto canopy using flat washer, lock washer, and short
screws.
B. Repeat other arms.
C. Make certain arms are aligned straight. If not, while
holding onto center plate turn canopy until they are
aligned.
3. Screw the long threaded pipe into coupler located at
bottom of socket assembly. Note correct position of
threaded pipe at illustration.
4. Follow enclosed “Multiple Standard Installation
Instructions” for electrical and fixture installation onto
ceiling outlet box.
5. Install bulbs (not included). See relamping label located
at socket area for type and maximum allowed wattage.
6. Slide glass shade through the long threaded pipe till it
rests onto bottom section of arms. Secure in position
by fastening with a washer and a hex nut. Do not over
tighten.
7. Slip cap and fasten finial onto threaded pipe.
Assembly Instructions For
SF246
Bulb
(not included)
Center Column
Socket
Canopy
(Fixture Plate)
Center Plate
Shade
Arm
Long
Threaded Pipe
Washer
Lock Washer
Short Screw
Flat Washer
Hex Nut
Cap
Finial
3
2
6
7
1
4
5
Ball Cap Nut