Feiss FM291 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb
not included.
1. Attach mounting bar securely to ceiling junction box with
two machine screws (supplied with junction box) through
slot at each end of mounting bar.
Note: mounting bar should be installed with "GND" imprint
and/or two dimples facing down.
2. Fasten one hex nut about 3/4" (19 mm) down from one end
of threaded pipe. Then screw same end of threaded pipe into
center hole in mounting bar. At this point test install the pan
onto ceiling through this threaded pipe and make certain 3/8"
(10 mm) of pipe protrude below. If not, then adjust the
threaded pipe location by screwing up or down accordingly.
Once correct threaded pipe location has been adjusted,
remove pan and tighten hex nut against mounting bar. Make
certain not to spin threaded pipe during tightening.
3. Spread the electrical wires so that the black wires are on one
side of the outlet box and the white wires are on the other
side.
4. Electrical connections:
Connect the white wire from the fixture to the white wire of
the outlet box. Connect the black wire from the fixture to
the black wire of the outlet box.
NOTE: Black outlet box wire may be red, round & smooth
and/or have copper conductor. White outlet box wire may be
square & ridged and/or have a silver conductor.
5. Grounding Connection:
Connect fixture ground wire (without insulation) to ground
wire from outlet box (usually with green insulation) with
wire connector (not provided).
IMPORTANT: Never connect ground wire to black or white
power supply wires.
6. Place pan thru top threaded pipe so that it sits flush against
ceiling. Be sure all wires are inside pan. Secure pan to ceiling
by fastening lock washer and coupler onto top threaded pipe.
Note: Coupler must turn at least 3 times, if it does not you
must remove coupler and lengthen threaded pipe accordingly.
7. Install bulb (not included). See relamping label located at
socket area for type and maximum allowed wattage.
8. Install the center pipe by screwing onto bottom of main
frame. Note correct position of center pipe at illustration.
9. A. Place metal ring onto glass plate. Then place shade.
B. While holding firmly onto glass plate, slip the assembled
parts through the long threaded pipe. And then slip cap and
lock them in position by fastening with a hex nut.
C. Install finial by screwing onto protruding threaded pipe.
Assembly Instructions For
FM291
Mounting Bar
Outlet Box
Mounting Screw
(not supplied)
Socket
Bulb
(not included)
Supply Ground Wire
Supply Wire
Fixture Wire
Fixture Ground Wire
Shade
Metal
Ring
Pan
Glass Plate
Hex Nut
Cap
Lock Washer
Coupler
Finial
(E) 12/09
Threaded Pipe
Long Threaded Pipe