Feiss FM335 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs
not included.
1. Attach mounting bar securely to ceiling junction box with
two machine screws (supplied with junction box) through
slot at each end of mounting bar.
Note: mounting bar should be installed with "GND" imprint
and/or two dimples facing down.
2. A. Fasten one hex nut about 3/4" (19 mm) down from one
end of threaded pipe.
B. Then screw same end of threaded pipe into center hole in
mounting bar.
C. At this point test install the pan onto ceiling through this
threaded pipe and make certain 3/8" (10 mm) of pipe
protrude below. If not, then adjust the threaded pipe location
by screwing up or down accordingly. Once correct threaded
pipe location has been adjusted, remove pan and tighten hex
nut against mounting bar. Make certain not to spin threaded
pipe during tightening.
3. A. Spread the electrical wires so that the black wires are on
one side of the outlet box and the white wires are on the
other side.
B. Electrical connections:
Connect the white wire from the fixture to the white wire of
the outlet box. Connect the black wire from the fixture to
the black wire of the outlet box.
NOTE: Black outlet box wire may be red, round & smooth
and/or have copper conductor. White outlet box wire may be
square & ridged and/or have a silver conductor.
C. Grounding Connection:
Connect fixture ground wire (without insulation) to ground
wire from outlet box (usually with green insulation) with
wire connector (not provided).
IMPORTANT: Never connect ground wire to black or white
power supply wires.
4. Place pan through threaded pipe so that it sits flush against
ceiling. Be sure all wires are inside pan. Secure pan to ceiling
by fastening with a hex nut. Then fasten cap nut.
5. Install bulb (not included). See relamping label located at
socket area for type and maximum allowed wattage.
6. A. Slip glass plate inside of main frame and allow to sit at
bottom.
B. Slip and hold main frame against the installed pan, making
certain the three threaded screws in pan are aligned with the
three tabs inside of main frame.
C. While firmly holding onto main frame, lift and tilt glass
plate toward one side then insert hand to fasten with three
cap nuts. See fig. 2.
Assembly Instructions For
FM335
(E) 11/09
6C
Fig. 2
6A
2
4
5
6B
1
3