Feiss FM330 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb
not included.
1. Install mounting plate:
A. Fasten two long machine screws (supplied) onto the
mounting plate (from the side opposite of green grounding
screw head). NOTE: Install onto holes corresponding with
fixture plate mounting holes.
B. Take supply wires from outlet box and carefully pass them
through center hole of mounting plate.
C. Install mounting plate onto the outlet box using two
screws supplied with outlet box.
D. Test install fixture plate to make certain about 1/4” (5mm)
of screws thread protrude outside of fixture plate. If not
then remove fixture plate and adjust screws length
accordingly. Secure screws length by fastening with two hex
nuts. Make certain not to spin screws during fastening. Place
fixture plate aside.
E. Spread electrical wires so that black wires are on one side
of the outlet box and the white wires are on the other side.
2. Connect electrical wires:
A. Connect white fixture wire(s) to white supply wire from
outlet box with wire connector. Connect black fixture
wire(s) to black supply wire from outlet box with wire
connector.
NOTE: Black outlet box wire may be red, round and smooth
and/or have copper conductor. White outlet box wire may
be square and ridged and/or have a silver conductor.
B. Connect fixture ground wire (without plastic insulation)
to ground wire from outlet box (usually with green
insulation) with wire connector.
Note: If there is no supply ground wire at outlet box then
attach fixture ground wire securely onto green grounding
screw located at mounting plate.
IMPORTANT: Never connect ground wire to black or white
supply wires (from outlet box).
3. Install fixture plate. While carefully tucking all electrical wires
inside of fixture plate, install the fixture plate onto the
mounting plate by fastening with two cap nuts.
4. Install light bulb (not included). See relamping label at socket
area for type and maximum allowed wattage.
Assembly Instructions For
FM330
Mounting Plate
Fixture Plate
Outlet Box
Mounting Screw
Bulb
(not included)
Supply Wire
Fixture Wire
Cap Nut
(E) 5/09
Ceiling Outlet Box
1
2
3
4