Feiss FM379 - Manual

1
Installation Instructions for
Turner 2 Light Flush Mount
1.0
FM379
Ceiling
FM379_
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory”
N R T L
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
1A
1
LAMP
SHADE
1
THUMB SCREW
SOCKET
2
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
MOUNTING PLATE
7
MOUNTING STUD
DECORATIVE RING
FIXTURE BASE
8
9
5 4
Secure the mounting plate to the electrical box with two mounting plate screws provided with electrical box.
Partially thread the two mounting studs into the mounting plate.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Align the key slots on the fixture base to the mounting plate studs, place the fixture base onto the mounting plate, secure it
by rotating it to the narrow portion of the keyed slot, and tighten the mounting studs until the fixture base is flush with the
ceiling.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Place the shade inside of the decorative ring and secure it in place using the tabs.
Install the shade and decorative ring by aligning them with the fixture base, then using the thumb screws to secure them in
place.
1
2
3
4
1
5
6
7
8
9
TAB
MOUNTING PLATE SCREW
6