Feiss VS1860_ - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs
not included.
1. Install mounting plate (see fig. 1):
A. Take supply wires from outlet box and carefully pass them
through center hole of mounting plate. Note: The flat surface
of mounting plate must face the outlet box and the angled
rim side facing toward you.
B. Install mounting plate onto the outlet box using two
screws supplied with outlet box.
C. Spread electrical wires so that black wires are on one
side of the outlet box and the white wires are on the other
side.
2. Connect electrical wires (see fig. 1):
A. Connect white fixture wire(s) to white supply wire from
outlet box with wire connector. Connect black fixture
wire(s) to black supply wire from outlet box with wire
connector.
NOTE: Black outlet box wire may be red, round and smooth
and/or have copper conductor. White outlet box wire may
be square and ridged and/or have a silver conductor.
B. Connect fixture ground wire (without plastic insulation)
to ground wire from outlet box (usually with green
insulation) with wire connector.
Note: If there is no supply ground wire at outlet box then
attach fixture ground wire securely onto green grounding
screw located at mounting plate.
IMPORTANT: Never connect ground wire to black or white
supply wires (from outlet box).
3. Install fixture plate. While carefully tucking all electrical wires
inside of fixture plate, install the fixture plate onto the
mounting plate by fastening with set screw. Use provided hex
key to tighten.
4. Install shade onto fitters by fastening with counter ring.
5. Install light bulb (not included). See relamping label at socket
area for type and maximum allowed wattage.
Assembly Instructions For
VS18601, VS18602, VS18603
(E) 12/10
1
2
3
4
5
Fig. 1
Fig. 2