ETC Sensor+ Portable Pack CEM+ to CEM3 Retrofit - Manual (Page 5)

Introduction 3
Overview of this Manual
Reference this manual throughout the retrofit procedure.
• Preparation, page 7 - emptying the rack and removing the external components
• Remove the CEM+ Backplane, page 8 - remove the existing backplane from the pack
• Replace Phase A Bus Bar, page 9 - remove the old bus bar and install a new one
• Attach New Power Harness, page 10 - install and secure the power wire harness
adapter
• Install CEM3 Backplane, page 10 - install the new backplane and connect and secure
the data cabling
• Replace AF Cards (AF Packs Only), page 12 - remove the existing Advanced Feature
cards and install the new ones
• Install New Pack Lid and Reassemble Pack, page 13 - install the new pack lid and
reassemble the external components
When viewing this document in electronic form (.PDF file) with Adobe Acrobat Reader, blue
italicized text followed by a page number such as “ Overview of this Manual, page 3 ” is a
link within the document. By clicking on the link, you can jump to that section or topic.