Other retrofit kits, Safety – ETC Sensor+ Portable Pack CEM+ to CEM3 Retrofit User Manual
Page 4
2
CEM3 Sensor+ Portable Pack Retrofit Manual
Other Retrofit Kits
This retrofit kit is for upgrading a Sensor+ CEM+ portable pack to a CEM3 portable pack.
Other kits are available for retrofitting other Sensor and Sensor+ dimming products.
Available retrofit kits include:
•
Sensor SP12 Portable Pack CEM3 Retrofit Kit - ETC Part # 7142K1001
•
Sensor SP24 Portable Pack CEM3 Retrofit Kit - ETC Part # 7142K1002
•
Sensor+ SP12+ Portable Pack CEM3 Retrofit Kit - ETC Part # 7142K1003
•
Sensor+ SP24+ Portable Pack CEM3 Retrofit Kit - ETC Part # 7142K1004
•
Sensor Installation Rack CEM3 Retrofit Kit - ETC Part # 7141K1001
•
Sensor+ Installation Rack CEM3 Retrofit Kit - ETC Part # 7141K1101
•
Sensor SP48 Touring Rack CEM3 Retrofit Kit - ETC Part # 7143K1001
•
Sensor SP96 Touring Rack CEM3 Retrofit Kit - ETC Part # 7143K1002
•
Sensor+ Touring Rack Universal CEM3 Retrofit Kit - ETC Part # 7143K1005
Safety
Please note the following safety warnings before use:
•
Disconnect power from the racks before all maintenance.
W A R N I N G :
Dimmer racks without an accessible power disconnect device cannot be
serviced safely. Before removing dimmer or control modules for service, de-
energize main feed to dimmer rack and follow appropriate Lockout/Tagout
procedures as described in NFPA Standard 70E. It is important to note that
electrical equipment such as dimmer racks can present an arc flash safety
hazard if improperly serviced. This is due to available large short circuit
currents on the feeders of the equipment. Any work on energized equipment
must comply with OSHA Electrical Safe Working Practices.