ETC Sensor+ Portable Pack CEM+ to CEM3 Retrofit - Manual (Page 15)

2
The Retrofit 13
Install New Pack Lid and Reassemble Pack
A new pack lid with the appropriate beacon board and Sensor3 sticker is included in the kit
Step 6:
Place the new Sensor3 pack lid partially in place and in the upright position over
the output connector side of the pack.
Step 7: Connect the new DMX ribbon cable to the blue connector on the rear of the
backplane and to the DMX connector on the beacon board in the pack lid.
Step 8: Connect the CAT 5 cable to the RJ-45 port on the rear of the backplane and to
the RJ-45 connector on the beacon board in the pack lid.
Step 9: Peel the backing off of the provided plastic wire retainer clip and stick it to the
center of the underside of the pack lid. Slide the DMX cable and the CAT5 cable
into the retainer clip...
Step 10: Lower the pack lid into place in a closed position.
Step 11: Secure the pack lid in place using the bolts and washers removed earlier. Use
three bolts and washers per side (6 total).
Up
Side View of Pack