Brother DR-250 - Manual (Page 4)

Photo 15
Photo 16
Photo 17
Photo 18
Photo 19
4 Brother DR-250 Technical Instructions
Step 13
Slide the drum axle out from the drum.
(See Photo 15)
Step 14
Lift out the drum from the cartridge.
Remove the gray drive gear from the end
of the drum. (See Photo 16)
N NO OT TE E:: The drive gear will need to be used
with the new drum. It is important not to
lose the gear.
Step 15
Remove the Philips screw holding the
metal gear housing end plate on the side
of the cartridge.
(See Photo 17)
Step 16
Release the two locking tabs that hold
the gear housing end plate in place.
(See Photo 18)
Remove the gear housing end plate.
Need trustworthy, detailed Technical
Instructions for another engine?
V isit: www.futuregraphicsllc.com
Step 17
Remove the large white gear and the
developer roller drive gear from the end
of the cartridge.
(See Photo 19)
Notes