Elkhart Brass Scorpion RF 8294-07 - Manual (Page 11)

11
Caution:
Do NOT change switch A position 1 on any transmitter. This switch is used
to set the priority setting of the transmitter and changing this switch may remove
override capabilities. In the event that switch A position 1 has been changed, off (down)
is for the primary controller, and on (up) is for any secondary controller.
Panel Mount RF Controller –
 Disconnect the power connector to the panel mount controller at the back of the panel.
 Open the back cover of the controller after loosening the screws.
 Remove the red and black power leads from the power conversion board and place the cover to
the side.
 Locate the security code switches on the circuit board (see Figure 2).
 Change the switches to the settings of the RF Receiver/Control Module except switch A position
1. One incorrect setting will prevent the system from working.
 Reconnect the power leads. The red lead is attached to the Positive (+) terminal, and the black
lead is attached to the Negative (-) terminal.
 Close the cover and replace the screws.
 Reconnect the power connector.
Important:
While reassembling the controller or transmitter, ensure wires and
antenna leads do not become pinched.