Elkhart Brass Scorpion 8394-04 - Manual (Page 12)

9
Locate relay box enclosure close enough to monitor so that the properly secured cable will
reach the monitor harness connection. The cable length is 36 inches.
Note: If longer cable is needed, the following extension cable lengths are available:
Relay Box to Monitor
Extension Cables
Part No. Length (Ft.)
81066000 2
81136000 4
81137000 6
81138000 8
81139000 10
¾ Mark enclosure-mounting holes on panel or bracket to which enclosure will be
mounted per dimensions in Figure 10.
¾ Drill (4) 11/32" diameter holes in panel or bracket.
¾ Remove (4) 5/16-18 bolts and lock washers from back of enclosure. Apply Loctite ®
#242 to bolts and install through panel or bracket into back of enclosure. Tighten
bolts.
¾ Attach six-pin cable connector to monitor harness near base of monitor.
¾ Secure cable to ladder or platform framing with cushioned wire clips in a manner to
prevent snagging by personnel, tools or equipment.
Figure 10
81480001 Relay Box Mounting Bolt Pattern
3. Primary Panel Mount Switch Module (81421001 and 81339001)
¾ Mark panel cutout and mounting screw pattern per dimensions in Figure 11.
¾ Cut rectangular clearance opening and drill four .140 in. diameter (#28 drill) holes.
¾ Insert cable connector, cable and switches through panel cutout. Secure unit to panel
with four (4) #8-32 type "F" thread cutting screws.