Doug Fleenor Design PRE10-A - Manual (Page 5)

Page 5 of 7
(Figure 2)
(Figure 1)
PRESET 10 ARCHITECTURAL - SETUP
FACEPLATE CONFIGURATION
Each Preset 10 Architectural has four jum pers, JP1 through JP4, that select different m odes of operation. The factory default
is to have all jum pers installed.
JP1 W hen this jum per is installed on the MASTER faceplate recording of presets is enabled. W hen rem oved, the TIME
and RECORD buttons are disabled. The position of JP1 on a SLAVE faceplate has no affect.
JP2 W hen this jum per is installed the faceplate takes on the MASTER duty. The MASTER faceplate is responsible for
transm itting and receiving DMX512, storing presets, and com m unicating with SLAVE faceplates. W hen rem oved, the
faceplate takes on the SLAVE duty. A SLAVE faceplate com m unicates button presses and m im ics the state of the
LEDs on the m aster faceplate.
JP3 W hen the jum per is installed the Preset 10 operates as an architectural preset station. W hen this jum per is rem oved
the Preset 10 operates as a console backup/portable station. This jum per m odifies the personality of the Preset 10
software.
JP4 W hen this jum per is installed it enables SINGLE ST ATION MODE. In this m ode the faceplate will not send any
"alternate start code" packets. W hen this jum per is rem oved it enables MULTI STATION MODE. This allows the
alternate start code packets required for m aster/slave station operation. If your system contains only one Preset 10,
there is no need to rem ove the jum per.
M ASTER AND SLAVE SELECTION
In a system with m ore than one faceplate only one MASTER is allowed. To m odify faceplate to becom e a MASTER which can
support SLAVE stations, the shunt located at JP2 should be installed and the shunt at JP4 should be rem oved. For safe
keeping place the shunt over only one of the pins at JP4.
To m odify a faceplate to becom e a SLAVE the shunts located at JP2 and JP4 should be rem oved. For safe keeping place the
shunt over only one of the pins at JP2 and JP4.